Series 2280 Precision DC Power Supply Reference Manual Section 2: General operation
077085503 / March 2019 2-87
To view system information using SCPI commands:
To retrieve the manufacturer, model number, serial number, and firmware version, send the
command:
*IDN?
To read the line frequency, send the command:
SYStem:LFRequency?
The firmware build, memory available, and calibration date are not available when using SCPI
commands.
Instrument sounds
The instrument emits a short beep when a front-panel key is pressed.
To turn the error beeper on or off from the front panel:
1. Press the MENU key.
2. Under System, select Settings.
3. Next to Beeper, select On or Off.
To turn the error beeper on or off using SCPI commands:
SYSTem:BEEPer:ERRor ON
SYSTem:BEEPer:ERRor OFF
To turn the key clicks on or off from the front panel:
1. From the home page, press the MENU key.
2. Under System, select Settings.
3. Next to Key Click, select On or Off.
To turn the key clicks on or off using SCPI commands:
SYSTem:KCLick ON
SYSTem:KCLick OFF
Resets
There are several types of resets in the Series 2280.
In general, the terms "reset," "instrument reset," and "system reset" refer to the reset that is
performed when you send the *RST or :SYSTem:PRESet command, or when you select MENU >
System > Settings > Reset from the front panel. For more information about the settings that get
reset, refer to Reset default values (on page 2-88). For more information about system reset, refer to
the topic Reset the instrument (on page 2-88).
To Next Page
Loading...
Need help?
General
