Keithley 2280 Series - Calibration:protected:save

Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference
077085503 / March 2019 7-43
:CALibration:PROTected:SAVE
This command saves the calibration to nonvolatile memory after the calibration procedure has been completed.
Type
Affected by
Where saved
Default value
Command only
Not applicable
Nonvolatile memory
Not applicable
Usage
:CALibration:PROTected:SAVE
Details
If the instrument exits the calibration mode by the following command without first saving the new
constants, the previous constants are restored.
:CALibration:STATe OFF
Example
:CAL:PROT:SAVE
Save calibration constants to memory.
Also see
None