Keithley 2280 Series - [:Source[N]]:Voltage:limit[:Amplitude]

Section 7: SCPI command reference Series 2280 Precision DC Power Supply Reference Manual
7-78 077085503 / March 2019
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]
This command selects the limit of voltage source.
Type
Affected by
Where saved
Default value
Command and query
Recall settings
Instrument reset
Power cycle
Save settings
32.5 V for Model 2280S-32-6
61 V for Model 2280S-60-3
Usage
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude] <value>
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]?
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]? DEFault
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]? MINimum
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]? MAXimum
[n]
Channel number: For single-channel instruments, the value is 1.
<value>
0 to 32 V for Model 2280S-32-6
0 to 60 V for Model 2280S-60-3
Details
This command sets the voltage limit. The Series 2280 cannot source voltage levels that exceed this
limit. When you change the voltage limit to a value that is smaller than the set value of voltage, the
voltage setting will be forced to voltage limit.
Example
:VOLT:LIM 15
Set the voltage limit to 15 V
Also see
[:SOURce[n]]:<function>[:LEVel][:IMMediate][:AMPLitude] (on page 7-77)