Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference
077085503 / March 2019 7-27
:CALCulate2:DATA?
This command reads the results of specified statistics.
Usage
:CALCulate2:DATA?
:CALCulate2:DATA? <channel>
The channel number (default value is CH1):
 Channel 1: CH1
Channel 2: CH2
Details
Return the calculation results of statistics. You can get the results in the following order:
 Minimum (MINimum)
 Maximum (MAXimum)
 Mean (MEAN)
 Standard deviation (SDEViation)
 Peak to peak (PKPK)
If the specified statistics have not been performed yet, the instrument will return -1.000000E+37.
If the buffer is empty, the instrument returns -1.000000E+37.
If there are a lot of readings stored in the buffer, some statistic operations may take too long and
cause a buffer time-out error. To avoid this, send the CALC2:DATA? command and then wait for the
message available (MAV) bit in the Status Byte Register to set before addressing the Series 2280 to
talk.
To Next Page
Loading...
Need help?
General
