Section 3: Functions and features Series 2280 Precision DC Power Supply Reference Manual
3-34 077085503 / March 2019
The following figure illustrates how the level trigger is activated when the current falls.
Figure 70: Current level trigger (fall)
List operation
You can use lists to set up the instrument to source specific voltage and current values to a device
under test (DUT). You can specify up to 99-step points of voltage and current limit. You can also
specify a different dwell time for each step.
When you run a list, the instrument uses the trigger model that contains the settings you selected for
the list.
To start a list, press HOME > List > Enable. You can also use an initiate command over the remote
interface.
To Next Page
Loading...
