Section 7: SCPI command reference Series 2280 Precision DC Power Supply Reference Manual
7-86 077085503 / March 2019
[:SOURce[n]]:LIST:MCOMPlete
This command specifies the time when the instrument generates the measure complete signal with list enabled.
Recall settings
Instrument reset
Power cycle
Usage
[:SOURce[n]]:LIST:MCOMPlete <type>
[:SOURce[n]]:LIST:MCOMPlete?
Channel number: For single-channel instruments, the value is 1
The time you can choose to generate :
 STEP: After each list step, the instrument will generate a measure complete
pulse; you can detect this pulse on digital I/O line 2; for more information,
refer to Digital I/O (on page 3-19)
 SWEEP: After each list cycle, the instrument will generate a measure
complete pulse; you can detect the pulse on digital I/O line 2
Detail
When the list is running, the instrument allows you to check measure complete single to acquire the
running state. You can use this command to configure the measure complete signal. For example,
the following figure shows the different output of measure complete signal in a three-point list.
Figure 99: Step and sweep
To Next Page
Loading...
Need help?
General
