Keithley 2280 Series - Output:delay:rising

Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference
077085503 / March 2019 7-55
:OUTPut:DELay:RISing
This command specifies the delay time that the instrument waits before turning on the specified output.
Type
Affected by
Where saved
Default value
Command and query
Recall settings
Instrument reset
Power cycle
Save settings
0
Usage
:OUTPut:DELay:RISing <n>
:OUTPut:DELay:RISing <n>,<channel>
:OUTPut:DELay:RISing?
:OUTPut:DELay:RISing? <channel>
:OUTPut:DELay:RISing? DEFault
:OUTPut:DELay:RISing? DEFault,<channel>
:OUTPut:DELay:RISing? MINimum
:OUTPut:DELay:RISing? MINimum,<channel>
:OUTPut:DELay:RISing? MAXimum
:OUTPut:DELay:RISing? MAXimum,<channel>
[n]
Delay rising time: 0 to 10 s with the resolution of 0.001 s.
<channel>
The channel number (default value is CH1):
 Channel 1: CH1
Channel 2: CH2
Details
This command sets the rising delay so that output will not turn on until the delay has elapsed. This
command affects off-to-on transitions, including the operation:
:OUTPut:STATe ON
Example
:OUTP:DEL:RIS 1
Set the rising delay time to 1 s.
Also see
:OUTPut:DELay:FALLing (on page 7-54)
:OUTPut[:STATe] (on page 7-59)