Keysight E4980AL - Page 439

Keysight E4980A/AL User’s Guide -439
Error Messages
Error Messages
-
message “:OUTP:DC:ISOL:LEV:AUTO ON” the message sent is received as an
undefined command by this instrument. See the command reference and use
the correct command.
-112 Program mnemonic too long
Program mnemonic is too long (maximum length is 12 characters).
-109 Missing parameter
The number of parameters is less than that required for the command, or the
parameter has not been entered. For example, the command “:CORR:USE”
requires one more parameter. Therefore, when a message “:CORR:USE” is sent
to a correct program message “:CORR:USE 11,” this instrument receives the
former message as an invalid one because all parameters have not been
entered.
Suggestion:
Enter command parameters correctly.
-108 Parameter not allowed
The number of parameters exceeds that required for the command. For
instance, when a program message “:FORM:BORD NORM, ASC” is sent instead
of a correct program message with a command “:FORM:BORD NORM”, which
requires a parameter, the instrument receives the message that the number of
parameters is invalid.
Suggestion:
See the command reference to confirm the required number of parameters.
-105 GET not allowed
GET is not allowed inside a program message.
-104 Data type error
Improper data type used (for example, string data was expected, but numeric
data was received).
-103 Invalid separator
The message unit separator (for example, “;”, “,”) is improper.
-102 Syntax error
Unrecognized command or data type was received.
-101 Invalid character
Invalid character was received.
-100 Command Error
Improper command.