48 Keysight E4980A/AL Precision LCR Meter
Display Format
MEAS DISPLAY Page
3-
Measurement parameter descriptions
The primary parameter measurement result is located on the upper line and
the secondary parameter measurement result is on the lower line in Figure 3-1
on page 46.
Each parameter is described below.
Table 3-2 Primary parameter
Parameter Description
Cp Capacitance value measured using the parallel equivalent circuit
model
Cs Capacitance value measured using the series equivalent circuit model
Lp Inductance value measured using the parallel equivalent circuit model
Ls Inductance value measured using the series equivalent circuit model
R Resistance
Z Absolute value of impedance
G Conductance
Y Absolute value of admittance
Vdc
1
DC voltage
1. This parameter can be set only when the E4980A is equipped with option 001.
Table 3-3 Secondary parameter
Parameter Description
D Dissipation factor
Q Quality factor (inverse of dissipation factor)
G Conductance
Rs Equivalent series resistance measured using the series equivalent
circuit model
Rp Equivalent parallel resistance measured using the parallel equivalent
circuit model
X Reactance
B Sustenance
Phase angle
Idc
1
DC current
To Next Page
Loading...
