126 Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide
9 Display Settings
For another method of seeing worst-case extremes of varying waveforms, see
"Glitch or Narrow Pulse Capture" on page 167.
To clear the display
Do one of the following:
• Press the [Clear Display] key.
• From the menu, choose Control > Clear Display.
• From the menu, choose Setup > Display.... In the Display dialog box's Waveform
Layout, Persistence, or Grids tabs, select Clear Display.
You can also configure the Setup > (Quick Action) menu item to clear the display. See
"Configuring the (Quick Action) Menu Item" on page 291.
To select the grid options
1 From the menu, choose Setup > Display....
2 In the Display dialog box, select the Grids tab.
3 You can use the following controls:
• Grid Intensity — Enter a value from 0 to 100%.
Each major vertical division in the grid corresponds to the vertical sensitivity
shown in the status line at the top of the display.
Each major horizontal division in the grid corresponds to the time/div shown
in the status line at the top of the display.
• Grid — This drop-down menu lets you select from these grid types:
• Full — the normal oscilloscope grid.
• Clear Display — Clears acquisition data from the oscilloscope display. This is
the same as pressing the front panel [Clear Display] key.
• Show Scales — When selected, grid value labels are shown along the grid's
horizontal and vertical axes.
To Next Page
Loading...
