276 Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide
22 Utility Settings
Manual
Configuration
1 Get the oscilloscope's network parameters (host name, IP address, subnet
mask, gateway IP, DNS IP, etc.) from your network administrator.
2 In the LAN Settings dialog box, select and enter values in these fields:
• IP Address — The oscilloscope's IP address.
• Subnet Mask — The oscilloscope's subnet mask.
• Gateway IP — The gateway IP address.
• DNS IP — You can enter the IP address of the Domain Name Server (DNS).
• Host Name — Lets you enter the oscilloscope's hostname.
The lower part of the LAN Settings dialog box shows the oscilloscope's Current
LAN Configuration.
3 Select Apply to apply the LAN settings changes.
Stand-alone (Point-to-Point) Connection to a PC
The following procedure describes how to establish a point-to-point (stand alone)
connection to the oscilloscope. This is useful if you want to control the
oscilloscope using a laptop computer or a stand-alone computer.
1 From the main menu, choose Utilities > I/O....
2 In the I/O dialog box, select the LAN Setup tab.
3 Select LAN Settings....
4 In the LAN Settings dialog box, select Automatic.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
5 Connect your PC to the oscilloscope using a cross-over LAN cable such as
Keysight part number 5061-0701, available on the web at
www.keysight.com/find/parts.
6 Cycle power on the oscilloscope.
Wait until the LAN connection status shows "configured" in the I/O dialog box's
I/O Overview tab.
This may take a few minutes.
Now, the instrument is connected, and the instrument's web interface or remote
control via LAN may be used.
Any time you modify the oscilloscope's hostname, it breaks the connection between the
oscilloscope and the LAN. You need to re-establish communication to the oscilloscope using
the new hostname.
To Next Page
Loading...
