Keysight InfiniiVision HD3 Series - Utility Settings; I;O Interface Settings

273
Keysight InfiniiVision HD3-Series Oscilloscopes
User's Guide
22 Utility Settings
I/O Interface Settings / 273
Setting up the Oscilloscope's LAN Connection / 274
File Explorer / 277
Setting Oscilloscope Preferences / 278
Setting the Oscilloscope's Clock / 281
Setting the Rear Panel AUX OUT Source / 282
Enabling Remote Command Logging / 282
Setting Enhanced Security Options / 283
Performing Service Tasks / 287
Configuring the (Quick Action) Menu Item / 291
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface on the rear panel.
When an I/O interface is installed, remote control over that interface is always
enabled. Also, the oscilloscope can be controlled via multiple I/O interfaces (for
example, USB and LAN) at the same time.
To configure the I/O interfaces:
1 From the main menu, choose Utilities > I/O....
2 In the I/O dialog box, select the LAN Setup tab.