Utility Settings 22
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 277
File Explorer
The File Explorer lets you navigate the oscilloscope's internal file system and the
file systems of connected USB storage devices.
From the internal file system, you can load oscilloscope setup files or mask files.
From a connected USB storage device, you can load setup files, mask files, license
files, firmware update (*.swu) files, label files, etc. Also, you can delete files on a
connected USB storage device.
The oscilloscope's internal file system, under "\User Files", consists of 10 locations
for oscilloscope setup files, four locations for mask files, and four locations for
waveform generator arbitrary waveform files.
To use the File Explorer:
1 From the main menu, choose File > File Explorer... or Utilities > File Explorer....
2 To navigate in the File Explorer dialog box, select devices, folders, and files.
3 When file(s) are selected, you can:
• Select Open File to loads the file selected in the bottom portion of the dialog
box.
• Select Delete File to deletes the file(s) selected in the bottom portion of the
dialog box.
The USB port on the front panel, and the USB port on the rear panel labeled "HOST" are USB
Series A ports. These are the ports to which you can connect USB mass storage devices.
The square port on the rear panel labeled "DEVICE" is provided for controlling the oscilloscope
over USB. See the Programmer's Guide for more information.
To Next Page
Loading...
