Keysight InfiniiVision HD3 Series - SPI Triggering and Protocol Decode; SPI Protocol Setup

347
Keysight InfiniiVision HD3-Series Oscilloscopes
User's Guide
28 SPI Triggering and Protocol
Decode
SPI Protocol Setup / 347
SPI Triggering / 350
Interpreting SPI Decode / 351
Interpreting SPI Lister Data / 352
Searching for SPI Data in the Lister / 352
SPI triggering and protocol decode is included with the Embedded Serial Analysis
license.
SPI Protocol Setup
To enable SPI protocol decode:
1 Press [Protocol Decode].
Or:
a From the main menu, choose Analyze > Protocol Decode....
b In the Protocol Decode dialog box, select Enable.
c Select either the P1 or P2 tab (the oscilloscope can decode two protocols at
the same time), and select On.
2 From the Mode drop-down list, select SPI.
Below the Mode selection are vertical tabs for specifying Signals and Settings.
NOTE
Only one SPI serial bus can be decoded at a time.