Getting Started 1
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 27
Input a Waveform
The first signal to input to the oscilloscope is the Probe Comp signal. This signal is
used for compensating probes.
1 Connect an oscilloscope probe from channel 1 to the Probe Comp terminal on
the front panel.
2 Connect the probe's ground lead to the ground terminal (below the Probe Comp
terminal).
Recall the Default Oscilloscope Setup
To recall the default oscilloscope setup:
1 Press [Default Setup].
The default setup restores the oscilloscope's default settings. This places the
oscilloscope in a known operating condition. The major default settings are:
In the Default dialog box (from the menu, choose Control > Default...), there are also
options for restoring the complete factory settings (see
"Recalling Default
Setups"
on page 271) or performing a secure erase (see "Performing a Secure
Erase" on page 272).
Do not negate the protective action of the ground connection to the oscilloscope.
The oscilloscope must remain grounded through its power cord. Defeating the
ground creates an electric shock hazard.
Horizontal Normal mode, 100 μs/div scale, 0 s delay, center time reference.
Vertical (Analog) Channel 1 on, 5 V/div scale, DC coupling, 0 V position, 1 MΩ impedance.
Trigger Edge trigger, Auto trigger mode, 0 V level, channel 1 source, DC coupling, rising
edge slope, 40 ns holdoff time.
Display Persistence off, 20% grid intensity, 50% waveform intensity.
Other Acquire mode normal, [Run/Stop] to Run, markers and measurements off.
Labels All custom labels that you have created in the Label Library are preserved (not
erased), but all channel labels will be set to their original names.
To Next Page
Loading...
