190 Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide
14 Measurements
Voltage Measurements
The following figure shows the voltage measurement points.
Measurement units for each input channel can be set to Volts or Amps using the
channel Probe Units softkey. See
"To specify the channel units" on page 61.
The units of math waveforms are described in "Units for Math Waveforms" on
page 78.
•
"Peak-Peak" on page 191
•
"Maximum" on page 191
• "Minimum" on page 191
• "Amplitude" on page 191
• "Top" on page 191
• "Base" on page 192
•
"Overshoot" on page 192
• "Preshoot" on page 193
"AC RMS" on page 195
"Time at Edge" on page 200 Yes
"Top" on page 191
"+ Width" on page 198 Yes
"– Width" on page 199 Yes
"X at Max Y" on page 202 Yes The resultant units are in Hertz.
"X at Min Y" on page 203 Yes The resultant units are in Hertz.
"Y at X" on page 191 Yes Yes With FFT waveforms, X is a frequency
value.
*
Use the markers to make other measurements on FFT.
Measurement Valid
for
Math
FFT
*
Valid for
Digital
Channels
Notes
Amplitude
Maximum
Minimum
Base
Top
Peak-Peak
To Next Page
Loading...
