Keysight InfiniiVision HD3 Series - CAN Triggering and Protocol Decode; CAN;CAN FD Protocol Decode Setup

319
Keysight InfiniiVision HD3-Series Oscilloscopes
User's Guide
25 CAN Triggering and Protocol
Decode
CAN/CAN FD Protocol Decode Setup / 319
Loading and Displaying CAN Symbolic Data / 323
CAN/CAN FD Triggering / 324
Interpreting CAN/CAN FD Decode / 326
Interpreting CAN Lister Data / 328
Searching for CAN Data in the Lister / 328
CAN triggering and protocol decode option is included with the Automotive Serial
Analysis license.
CAN/CAN FD Protocol Decode Setup
To enable CAN/CAN FD protocol decode:
1 Press [Protocol Decode].
Or:
a From the main menu, choose Analyze > Protocol Decode....
b In the Protocol Decode dialog box, select Enable.
c Select either the P1 or P2 tab (the oscilloscope can decode two protocols at
the same time), and select On.
2 From the Mode drop-down list, select CAN.
Below the Mode selection are vertical tabs for specifying Signals and Settings.
Signals Setup consists of connecting the oscilloscope to a CAN signal, using the Signals
subtab controls to specify the signal source, threshold voltage level, baud rate,
and sample point.