Keysight InfiniiVision HD3 Series - In this Guide

Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 5
In This Guide
This guide shows how to use the InfiniiVision HD3-Series oscilloscopes.
When unpacking and using the
oscilloscope for the first time, see:
•
Chapter 1, “Getting Started,” starting on page 19
When displaying waveforms and
acquired data, see:
•
Chapter 2, “Horizontal Controls,” starting on page 45
• Chapter 3, “Vertical Controls,” starting on page 55
• Chapter 4, “FFT Spectral Analysis,” starting on page 65
• Chapter 5, “Math Waveforms,” starting on page 75
• Chapter 6, “Reference Waveforms,” starting on page
99
• Chapter 7, “Digital Channels,” starting on page 103
• Chapter 8, “Protocol Decode,” starting on page 119
• Chapter 9, “Display Settings,” starting on page 123
When setting up triggers or changing
how data is acquired, see:
• Chapter 10, “Triggers,” starting on page 135
• Chapter 11, “Trigger Mode and Conditioning,” starting
on page 153
• Chapter 12, “Acquisition Control,” starting on page
161
Making measurements and analyzing
data:
•
Chapter 13, “Markers,” starting on page 177
• Chapter 14, “Measurements,” starting on page 185
• Chapter 15, “Histogram,” starting on page 213
• Chapter 16, “Mask Testing,” starting on page 221
• Chapter 17, “Digital Voltmeter and Counters,” starting
on page 235
• Chapter 18, “Fault Hunter,” starting on page 239
• Chapter 19, “Frequency Response Analysis,” starting
on page 245
When using the built-in waveform
generator, see:
•
Chapter 20, “Waveform Generator,” starting on page
249
When saving or recalling files, see: •
Chapter 21, “Save/Email/Recall (Setups, Screens,
Data),” starting on page 261
When using the oscilloscope's utility
functions or web interface, see:
• Chapter 22, “Utility Settings,” starting on page 273
• Chapter 23, “Web Interface,” starting on page 293