Keysight InfiniiVision HD3 Series - To Establish a LAN Connection

Utility Settings 22
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 275
Once the oscilloscope is set up on the network, you can use the oscilloscope's web
page to view or change its network configuration and access additional settings
(like the network password). See
Chapter 23, “Web Interface,” starting on page
293.
To establish a LAN connection
Oprn the LAN
Settings Dialog
Box
1 From the main menu, choose Utilities > I/O....
2 In the I/O dialog box, select the LAN Setup tab.
3 Select LAN Settings... to open the LAN Settings dialog box.
Automatic
Configuration
1 In the LAN Settings dialog box, select Automatic.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
2 You can enable the Multicast DNS option to let the oscilloscope use Multicast
DNS for name resolution on small networks without a conventional DNS server.
3 Connect the oscilloscope to the local area network (LAN) by inserting the LAN
cable into the "LAN" port on the rear panel of the oscilloscope.
In a few moments the oscilloscope will connect to the network automatically.
If the oscilloscope does not automatically connect to the network, select LAN
Reset in the I/O dialog box's LAN Setup tab. In a few moments the oscilloscope
will connect to the network.
NOTE
When you connect the oscilloscope to a LAN it is a good practice to limit access to the
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See "Setting a Password" on page 302 to set a password.
NOTE
Any time you modify the oscilloscope's hostname, it breaks the connection between the
oscilloscope and the LAN. You need to re-establish communication to the oscilloscope using
the new hostname.