Keysight InfiniiVision HD3 Series - Page 23

Getting Started 1
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 23
R-R-Kst-1A23875
40
CAN ICES/
NMB-001(A)
ISM GRP 1-A
~
275 Watts MAX
100-240V, 50/60Hz
100-120V, 50/60/400Hz
~
AUX
TRIG
IN
DIGITAL D15-D0
AUX
OUT
AUX
TRIG
IN
GEN
OUT
DIGITAL D15-D0
AUX
OUT
AUX
TRIG
IN
GEN
OUT
4. USB Device port
3. USB Host port
9. Kensington lock hole
6. AUX OUT connector
7. AUX TRIG IN connector
8. Digital channel inputs
2. LAN port
5. GEN OUT connector
1.Power cord
connector
1. Power cord
connector
Attach the power cord here.
2. LAN port Lets you place the oscilloscope on the network for access the built-in web
server and remote programming. See Chapter 23, “Web Interface,”
starting on page 293 and "Remote Programming with Keysight IO
Libraries" on page 296.
3. USB Host port This port functions identically to the USB host ports on the front panel.
USB Host Port is used for saving data from the oscilloscope and loading
software updates.
4. USB Device port This port is for connecting the oscilloscope to a host PC. You can issue
remote commands from a host PC to the oscilloscope via the USB device
port. See "Remote Programming with Keysight IO Libraries" on
page 296.
5. GEN OUT
connector
Built-in, license-enabled waveform generator can output arbitrary, sine,
square, ramp, pulse, DC, noise, sine cardinal, exponential rise, exponential
fall, cardiac, or Gaussian pulse waveforms on the GEN OUT BNC
connector. Modulated waveforms are available except for arbitrary, pulse,
DC, and noise waveforms. Press the [Wave Gen] key to set up the
waveform generator. See
Chapter 20, “Waveform Generator,” starting on
page 249.