Web Interface 23
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 303
To set a password:
1 Access the oscilloscope's web interface (see "Accessing the Web Interface" on
page 294).
2 When the oscilloscope's web interface is displayed, select the gear icon in the
upper-right corner of the web page.
3 Click the Enable password button.
4 Enter your desired password in the New Password field. Enter the password
again in the Confirm Password field. Click Enable Password.
When a password is enabled for the web interface, Log out or Log in appears in
the upper-right corner next to the gear icon.
To change or
disable the
password
Do one of these things:
• Select the gear icon in the upper-right corner of the web page. In the Password
Options page, click Change Password or Disable Password.
• Another way to disable the password is to reset the oscilloscope's LAN settings.
To do this, select the Configure LAN tab, select Advanced options, and select
LAN Reset.
• You can also reset the oscilloscope's LAN settings from the oscilloscope's
graphical user interface:
a Choose Utility > I/O....
b In the I/O dialog box, select the LAN Setup tab.
c Select LAN Reset.
To Next Page
Loading...
