Keysight InfiniiVision HD3 Series - Page 41

Getting Started 1
Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide 41
• Draw box mode — Drag a box and release to access a menu of possible
actions for the selected waveform area.
• Cancel — Closes the popup menu.
• Horizontal Waveform Zoom — Changes the horizontal scaling and position to
zoom the waveform within the drawn box. See
Chapter 2, “Horizontal
Controls,” starting on page 45.
• Waveform Zoom — Changes the horizontal scaling and position, as well as the
vertical scaling and offset, to zoom the waveform within the drawn box. See
Chapter 2, “Horizontal Controls,” starting on page 45 and Chapter 3,
“Vertical Controls,” starting on page 55.
• Add Zone Trigger - Must Intersect, Add Zone Trigger - Must Not Intersect, Replace
Zone Trigger - Must Intersect, Replace Zone Trigger - Must Not Intersect — Adds or
replaces triggering zones based on the drawn box. See "Zone Qualified
Trigger"
on page 149.
• Histogram — Turns on a histogram using the drawn box to define the
histogram window limits. See
"Waveform Histogram Set Up" on page 214.
• Place X Markers here — Turns on manual markers using the left and right sides
of the drawn box as the X marker positions. See
"To make marker
measurements" on page 178.
• Add Annotation — Adds an annotation at the upper-left corner of the drawn
box. See
"To add an annotation" on page 130.
• Drag waveforms mode — Drag a waveform left or right in the grid to
change the horizontal position. Drag a waveform up or down in the grid to
change the vertical offset.