267
Reference
7. Press Save to confirm. A dialog box appears, asking you to
select one of the available User locations inside the folder:
In the dialog box above, the previously selected bank of
Styles will be saved to the bank User 01 (corresponding to
the USER1 button) inside the selected folder. Three User
banks are available.
8. Press OK to confirm, or Cancel to abort.
Warning: After confirming, the same bank in the target
folder is deleted.
Saving a single item
You can save a single User item with a single operation.
1. If saving on a floppy disk, insert the disk into the disk drive.
2. The full content (“All”) of the internal memory is already
shown. Select it, and press Open to open it. A list of User
data types appear (each type is a separate folder).
3. Select the folder containing the type of data you wish to
save, and press Open to open it. The list of contained banks
is shown.
4. Select the desired bank, and press Open to gain access to
the single files.
5. Once you have selected the file that you want to save, press
Save To to confirm the selection. The list of files of the tar-
get device is shown.
6. If needed, select a different target device, by using the
Device pop-up menu. When the target device is selected, its
content will appear in the display.
7. At this point, you can:
• Press the New SET button and create a new “.SET” folder
(see “Creating a new “.SET” folder” on page 268), or
• Select an existing “.SET” folder.
8. Press Save to confirm. A dialog box appears, asking you to
select one of the available User locations inside the selected
folder
In the dialog box above, the previously selected Style will be
saved to location 01 inside the bank U01 (corresponding to
the USER1 button) inside the selected folder.
9. Press OK to confirm, or Cancel to abort.
Warning: After confirming, the same item in the target
folder is deleted.
To Next Page
Loading...
