Lexmark C935 - Page 107

Diagnostic information 2-15
5057-XXX
Go Back
Previous
Next
941.01
Service tray 1
failure
sensor (media level) late
error (tray 1)
The sensing area of the sensor (media level) in the
media tray 1 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to “941.01 Sensor (media level) late error
(tray 1)” on page 2-113.
942.00
Service tray 2
failure
Switch (media size) size
sensing error (tray 2)
The tray 2 switch (media size) detected an invalid
size setting.
Go to “942.00 Switch (media size) size sensing
error (tray 2)” on page 2-114.
942.01
Service tray 2
failure
Sensor (media level) late
error (tray 2)
The sensing area of the sensor (media level) in the
media tray 2 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to “942.01 Sensor (media level) late error
(tray 2)” on page 2-115.
943.00
Service tray 3
failure
Switch (media size) size
sensing error (tray 3)
The tray 3 switch (media size) detected an invalid
size setting.
Go to “943.00 Switch (media size) size sensing
error (tray 3)” on page 2-116.
943.01
Service tray 3
failure
Sensor (media level) late
error (tray 3)
The sensing area of the sensor (media level) in the
media tray 3 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to “943.01 Sensor (media level) late error
(tray 3)” on page 2-117.
944.00
Service tray 4
failure
Switch (media size) size
sensing error (tray 4)
The tray 4 switch (media size) detected an invalid
size setting.
Go to “944.00 Switch (media size) size sensing
error (tray 4)” on page 2-118.
944.01
Service tray 4
failure
Sensor (media level) late
error (tray 4)
The sensing area of the sensor (media level) in the
media tray 4 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to “944.01 Sensor (media level) late error
(tray 4)” on page 2-119.
980.00
Service tray 2
comm.
Communication error with
1TM, 3TM or TTM assembly
A communication error has occurred with the
1TM,3TM or TTM controller card assembly and the
upper printer engine card assembly.
Go to “980.00 Communication error with 1TM,
3TM, or TTM assembly” on page 2-125.
Error code or
message
Error contents Description/Action