Lexmark C935 - K Maintenance Required

Diagnostic information 2-137
5057-XXX
Go Back
Previous
Next
600K maintenance required
ADF maintenance required
Standard media bin full
Step Check Yes No
1 Install the 600K maintenance kit.
Does the message still occur?
Reset the 600K
maintenance
counter.
Go to “Scheduled
maintenance” on
page 6-2.
Problem solved.
Step Check Yes No
1 Install the ADF maintenance kit.
Does the message still occur?
Reset the ADF
maintenance
counter.
Go to “Scheduled
maintenance” on
page 6-2.
Problem solved.
Step Check Yes No
1 Check the actuator for movement.
Does the standard media bin full actuator move up and
down normally?
Go to step 2. Reinstall the
standard media
bin full actuator.
2
Check the sensor (standard bin full exit 1) for operation.
1. Enter the Diagnostics Menu.
2. Select BASE SENSOR TEST.
3. Select Exit level.
4. Select Standard bin full 1.
Does the display, on the operator panel, change every time
the sensing area is blocked?
Go to step 5. Go to step 3.
3
Check the sensor (standard media bin full) connection.
Is the sensor (standard bin full 1) properly connected?
Replace the
sensor (standard
media bin full).
Go to “Sensor
(standard media
bin full) removal”
on page 4-21.
Replace the
connection.
Go to step 4.
4
Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-90.
Problem solved.