Lexmark C935 - Sheet Dual Input (Ttm)-Media Feed Unit Assembly Removal (Tray 4)

4-136 Printer Service Manual
5057-XXX
Go Back
Previous
Next
10. Remove the tray 4 front cables (C) from the bottom plates (F).
Replacement note: Before re-installing:
– It is recommended that all four cables be replaced.
– Ensure tray 4 front cables (C) are not twisted or kinked.
– Route the cables properly as shown in the figure.
– Replace the cables by setting the frame assembly (B) on its side as shown in the figure.
2000-sheet dual input (TTM)—media feed unit assembly removal (tray 4)
1. Remove the media tray 2 assembly.
2. Remove the tray module left cover. See “2000-sheet dual input (TTM)— tray module left cover removal” on
page 4-123.
3. Remove the media tray 3 assembly. See “2000-sheet dual input (TTM)—TTM media tray 3 assembly removal”
on page 4-128.
4. Remove the media tray 4 assembly. See “2000-sheet dual input (TTM)—TTM media tray 4 assembly removal”
on page 4-127.
5. Remove the tray 4 media transport assembly. See “2000-sheet dual input (TTM)—TTM tray 4 media transport
assembly removal” on page 4-132.
6. Disconnect the two connectors from the media feed unit assembly (A).