Lexmark C935 - Hard Drive Removal

Repair information 4-87
5057-XXX
Go Back
Previous
Next
3. Remove the RIP card assembly (A) from the machine.
4. Remove the riser card assembly. See “Interconnect card assembly removal” on page 4-88.
Replacement warning: When replacing the RIP card assembly, ensure the interconnect card assembly is
removed from the defective RIP card assembly and installed on the replacement rip card assembly or the
machine will not function.
Hard drive removal
1. Remove the RIP card assembly. See “RIP card assembly removal” on page 4-86.
Warning: Do not drop the RIP card assembly, or damage will occur.
2. Remove the two connectors from the hard drive (A).
3. Remove the four screws securing the hard drive (B) to the side of the RIP card assembly (A).
4. Remove the hard drive (B).
Warning: Do not drop the hard drive, or damage will occur.