Lexmark C935 - Media Transport Path

1-44 Printer Service Manual
5057-XXX
Go Back
Previous
Next
Media transport path
The following is a cross section of the printer and the tandem tray module, showing the main components
directly associated with the media path and transport.
Functions of main components
When the 3TM is installed under the printer, additional trays are available.
Media tray assembly
It is necessary to adjust the rear and the end guide in the media tray assembly to match the media size.
Rear media guide
The rear media guide can be adjusted to different media sizes by moving it to the front or rear. The guide comes
into contact with the rear edge of the media and holds it in position.
MPF
Tray 1
Registration roll assembly
Bridge unit assembly
(included with finisher)
Standard media exit
roll assembly
Fuser exit
roll assembly
Duplex media
transport roll
assembly
Fuser
Finisher
(optional)
Booklet maker unit
(optional)
Finisher media entrance
roll assembly
Upper media exit
roll assembly
Upper media
transport roll assembly
Buffer roll assembly
Lower media exit
roll assembly
Booklet media
transport roll assembly
Booklet media
entrance roll assembly
Booklet media
exit roll assembly
Booklet folding
roll assembly
Media eject
roll assembly
2nd transfer roll assembly
MPF pick roll
Media transport roll assembly
Tray 2
Tray 3
Tray 4
3TM (optional)
Tray module transport
roll assembly
1TM (optional)
Tray 2
Tray module transport
roll assembly
Tray 2
Tray 3
Tray 4
TTM
Tray 4 transport roll assembly
Pick roll
Feed roll
Separation roll
Bridge unit bin exit
roll assembly