Lexmark C935 - Sensor (CMY Transfer Roll Retract HP) Lag Error

Diagnostic information 2-91
5057-XXX
Go Back
Previous
Next
904.06 Sensor (CMY transfer roll retract HP) lag error
Step Check Yes No
1 Check the transfer belt unit assembly.
Is the above component properly installed?
To to step 2 Properly reinstall
the transfer belt
unit assembly.
2
Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 3. Perform several
print tests.
If the problem
remains, go to
step 3.
3
Did the error occur following a developer unit replacement? Verify the
developers are
installed correctly.
See “Developer
unit assembly
removal” on
page 4-53.
Go to the next
step.
4
Check to ensure that the transfer belt lift mechanism is
functioning properly. See “Transfer belt lift mechanism
adjustment” on page 4-228.
Does the error remain?
The problem is
resolved.
Contact the next
level of support.