Lexmark C935 - Belt Edge Learn Test

Repair information 4-217
5057-XXX
Go Back
Previous
Next
Belt edge learn test
Skew fine setup
Step Check Yes No
1 Perform the Belt edge learn test.
1. Enter the Diagnostics Menu.
2. Select ENGINE ADJUST.
3. Select RegCon adjust
4. Select Belt edge learn
Does the above test pass?
Perform “Skew
setup”.
See “Skew fine
setup” on
page 4-217.
Go to step 2.
2
Replace the transfer belt unit assembly.
See “Transfer belt unit assembly removal” on
page 4-16.
Does the error continue?
Perform “Skew
setup”.
See “Skew fine
setup” on
page 4-217.
Contact next level
of support.
Step Check Yes No
1 Perform the Skew fine setup.
1. Enter the Diagnostics Menu.
2. Select ENGINE ADJUST.
3. Select RegCon adjust
4. Select Control setup cycles
5. Select Skew fine setup
Does the above test pass?
Go to step 2. Go to step 3.