Lexmark C935 - Sensor (Media on Belt) Removal

4-30 Printer Service Manual
5057-XXX
Go Back
Previous
Next
Replacement warning: When replacing the printer left door assembly (D), ensure that the duplex media exit turn
guide (E) is held in its upper-most position, or the printer left door assembly (D) will not close properly.
Sensor (media on belt) removal
1. Open the printer left door assembly.
2. Remove the screw securing the sensor (media on belt) (A) to the machine.
3. Disconnect the connector from the sensor (media on belt) (A).
4. Remove the sensor (media on belt) (A).
E
D