Lexmark C935 - XX RIP Card Assembly NVRAM Failure

Diagnostic information 2-121
5057-XXX
Go Back
Previous
Next
951.XX RIP card assembly NVRAM failure
952.XX Interconnect card assembly NVRAM CRC failure
1 Check the interconnect card assembly.
Was the interconnect card assembly recently replaced?
Go to step 3. Go to step 2.
2 Check the RIP card assembly.
Was the RIP card assembly recently replaced?
Go to step 4. Contact next level
of support.
3 Replace the current interconnect card assembly with the
original interconnect card assembly.
Does the error remain?
Go to step 5 Problem solved.
4 Replace the current RIP card assembly with the original RIP
card assembly.
Go to “Interconnect card assembly removal” on
page 4-88.
Does the error remain?
Go to step 6. Problem solved.
5 If problem remains, replace the original interconnect card
assembly with a new and not previously installed
interconnect card assembly.
Does the error remain?
Contact the next
level of support.
Problem solved.
6 If problem remains, replace the original panel assembly with
a new and not previously installed interconnect card
assembly.
Go to “Interconnect card assembly removal” on
page 4-88.
Does the error remain?
Contact the next
level of support.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-86.
Go to step 3.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.