Lexmark C935 - Sheet Dual Input (Ttm)-Sensor (Tray 2 Feed-Out) Removal

4-144 Printer Service Manual
5057-XXX
Go Back
Previous
Next
2000-sheet dual input (TTM)—sensor (tray 2 feed-out) removal
1. Open the TTM left door assembly.
2. Remove the two screws securing bracket (A) to the machine.
3. Remove the bracket (A).
4. Disconnect the connector from the sensor (tray 2 feed-out) (B).
5. Release the hooks securing the sensor (tray 2 feed-out) (B) to the bracket (A).
6. Remove the sensor (tray 2 feed-out) (B).
2000-sheet dual input (TTM)—media feed lift motor removal
1. Remove the tray module left cover. See “2000-sheet dual input (TTM)— tray module left cover removal” on
page 4-123.
2. Remove the media tray 3 assembly. See “2000-sheet dual input (TTM)—TTM media tray 3 assembly removal”
on page 4-128.
3. Remove the media tray 4 assembly. See “2000-sheet dual input (TTM)—TTM media tray 4 assembly removal”
on page 4-127.
4. Remove the tray 4 media transport assembly. See “2000-sheet dual input (TTM)—TTM tray 4 media transport
assembly removal” on page 4-132.
5. Remove the media feed unit assembly. See “2000-sheet dual input (TTM)—media feed unit assembly 2
removal” on page 4-141 or “2000-sheet dual input (TTM)—media feed unit assembly removal (tray 4)” on
page 4-136.
6. Disconnect the harness from the media feed lift motor (A).
7. Remove the two screws securing the media feed lift motor to the media feed unit assembly (B).