Lexmark C935 - Sensor (Tray 1 Feed-Out) Late Jam (Feeding from Tray 2)

2-40 Printer Service Manual
5057-XXX
Go Back
Previous
Next
242.01 Sensor (tray 1 feed-out) late jam (feeding from tray 2)
7
Check the media feed lift motor in media tray 2 for proper
operation.
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
1. Enter the Diagnostics Menu.
2. Select MOTOR TESTS.
3. Select Printer motor tests.
4. Select Tray 2 media feed/lift motor.
Does the above component operate properly?
Go to step 9. Skip to step 8.
8
Check the media feed lift motor for proper connection.
Is the above component properly connected?
Replace the media
feed lift motor.
Go to “Media feed
lift motor
removal” on
page 4-120.
Replace the
connection.
9
Perform a print test.
Does the error continue?
Replace the lower
printer engine card
assembly.
Go to “Lower
printer engine
card assembly
removal” on
page 4-93.
Problem solved.
Step Check Yes No
1 Check the media condition.
Is the media in the tray crumpled or damaged?
Replace the
damaged media
with new.
Go to step 2.
2
Check the media position.
Does the media touch the sensor (tray 1 feed-out)?
Remove the
media.
Go to step 5.
3
Check the sensor (tray 1 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Select INPUT TRAY TESTS.
3. Select Sensor test.
4. Select Tray 1.
5. Select Feed-out.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
Go to step 5.
Go to step 4.
4
Check the sensor (tray 1 feed-out) for proper connection.
Is the above component properly connected?
Replace the
sensor (tray 1
feed-out).
Replace the
connection.
Step Check Yes No