Lexmark C935 - Transfer Belt Lift Latch Assembly Removal

Repair information 4-63
5057-XXX
Go Back
Previous
Next
Replacement warning: When replacing the PC unit assembly (C), ensure that the rail on the PC unit assembly
(C) is properly inserted into the metal track or physical binding and damage will occur. In the event that the PC
unit assembly (C) becomes bound, it can be removed by twisting it in a clockwise direction while pulling it from
the machine.
Transfer belt lift latch assembly removal
1. Remove the printer front door assembly. See “Printer front door assembly removal” on page 4-3.
2. Remove the front left cover. See “Front left cover removal” on page 4-9.
3. Remove the waste toner cartridge cover. See “Waste toner cartridge cover removal” on page 4-39.
4. Remove the waste toner cartridge sensor assembly. See “Waste toner cartridge sensor assembly removal”
on page 4-39.
5. Remove the sensor (waste toner cartridge full). See “Sensor (waste toner cartridge full) removal” on
page 4-40.
6. Remove the inner cover. See “Inner cover removal” on page 4-42.
7. Remove the two screws securing the transfer belt lift latch (A) to the machine.
8. Release the harnesses from the clamp.
Metal
track
A1
Rail must slide straight
into metal track
C