2-124 Printer Service Manual
5057-XXX
956.01 RIP card assembly processor over temperature failure
956.02 RIP card assembly cooling fan failure
956.03 RIP card assembly FPGA failure
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Go to step 3. Problem solved.
3 Check the RIP card cooling fan and heatsink for proper
installation.
Is the RIP card cooling fan and heatsink installed correctly?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-86.
Install the RIP
card cooling fan
and heatsink
correctly.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Go to step 3. Problem solved.
3 Checking the RIP card assembly cooling fan and heatsink
attachment.
Is the above fan attached properly?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-86.
Reattach the RIP
card assembly
cooling fan and
heatsink.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-86.
Problem solved.