Lexmark C935 - Transfer Belt Lift Handle Assembly Removal

4-70 Printer Service Manual
5057-XXX
Go Back
Previous
Next
Transfer belt lift handle assembly removal
Warning: When replacing the transfer belt lift handle assembly, the two transfer belt lift mechanisms must be
correctly timed or print quality problems and damage will occur.
Replacement warning: After replacing the transfer belt lift handle assembly (B), the two transfer belt lift
mechanisms must be correctly aligned or print quality problems and damage will occur. Once the alignment is
correctly set, replace the two plastic rack gear caps.
Replacement warning: When replacing the transfer belt lift handle assembly (B), ensure the two timing marks
on the two sector gears are aligned with the two timing knotches in the two rack gears.
Replacement warning: Gently raise and lower the transfer belt lift handle assembly (B) and ensure that the lift
mechanicsm is aligned properly and no binding occurs
1. Remove the front door assembly. See “Printer front door assembly removal” on page 4-3
2. Remove the waste toner bottle.
3. Remove the right cover assembly. See “Right cover assembly removal” on page 4-4.