Lexmark C935 - XX RIP Card Assembly Software Error

Diagnostic information 2-63
5057-XXX
Go Back
Previous
Next
901.xx RIP card assembly software error
902.00 General upper engine error fuse #1
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2
Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-86.
Go to step 3.
Problem solved.
3
Perform a POR.
Does the error occur when the power is turned off/on?
Replace the upper
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-90.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2
Check the rear upper cooling fan cables and any associated
cables for damage.
Are the above components free from crimps and damage?
Go to step 3. Repair or replace
the appropriate
cable assemblies
or replace the rear
upper cooling fan.
Go to “Rear
upper cooling fan
removal” on
page 4-111.
3
Check the rear lower cooling fan cables and any associated
cables for damage.
Are the above components free from crimps and damage?
Go to step 4. Repair or replace
the appropriate
cable assemblies
or replace the rear
lower cooling fan
assembly.
Go to “Rear lower
cooling fan
assembly” on
page 4-99.