Lexmark C935 - Sheet Dual Input (Ttm)-One-Way Clutch; Gear Assembly Removal

4-146 Printer Service Manual
5057-XXX
Go Back
Previous
Next
2000-sheet dual input (TTM)—one-way clutch / gear assembly removal
1. Remove the tray module left cover. See “2000-sheet dual input (TTM)— tray module left cover removal” on
page 4-123.
2. Remove the media tray 3 assembly. See “2000-sheet dual input (TTM)—TTM media tray 3 assembly removal”
on page 4-128.
3. Remove the media tray 4 assembly. See “2000-sheet dual input (TTM)—TTM media tray 4 assembly removal”
on page 4-127.
4. Remove the tray 4 media transport assembly. See “2000-sheet dual input (TTM)—TTM tray 4 media transport
assembly removal” on page 4-132.
5. Remove the media feed unit assembly. See “2000-sheet dual input (TTM)—media feed unit assembly 2
removal” on page 4-141, “2000-sheet dual input (TTM)—media feed unit assembly removal (tray 3)” on
page 4-141, or “2000-sheet dual input (TTM)—media feed unit assembly removal (tray 4)” on page 4-136.
6. Remove the harness from the bracket (A).
7. Remove the three screws securing the bracket (A) to the media feed unit assembly.
8. Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
9. Remove the tray lift one-way clutch (B).
Harness
Washer
Clamp
A
Rear
B