Diagnostic aids 3-27
5057-XXX
Factory Defaults
Warning: This operation cannot be undone.
This setting enables you to restore all of the printer’s settings to the base printer settings, the network settings,
or to remove all Lexmark Embedded Solutions (LES) applications.
To restore the Factory Default settings:
1. Select Factory Defaults from the Configuration Menu.
2. Select Restore Base to restore all non-critical base printer NVRAM settings.
3. Select Restore Network to restore all network NVRAM settings.
4. Select Restore LES to remove all Lexmark Embedded Solution applications
.
When you select either value, the LCD displays Restoring Factory Defaults and then Resetting the Device.
The device immediately performs a POR and restores the appropriate settings to their factory default values.
The following settings are not changed:
• Display Language (general settings)
• Network/Ports Menu
• Standard USB, USB (x) Menus (if an ENA is installed)
Energy Conserve
This menu controls what values appear on the Power Saver menu. If Off is selected in the Energy Conserve
menu, then Disabled appears in the Power Saver menu, and Power Saver can be turned off. If On is set in the
Energy Conserve menu, the Power Saver feature cannot be disabled.
To change this setting:
1. Select Energy Conserve from the Configuration Menu.
2. Select Back to cancel and return to the Configuration Menu.
3. Select to save the change.
EVENT LOG (Configuration Menu)
This entry enables you to print a report that contains a limited set of the information that appears in the
Diagnostics version of the Event Log report. See “EVENT LOG” on page 3-17. The limited (Configuration) and
the full (Diagnostics) printed versions of this report display the same panel messages when they print and follow
the same layout guidelines.
To print the Event Log:
1. Select EVENT LOG from the Configuration Menu.
2. Select Print Log.
Select Back to return to the Configuration Menu.
Note: An event log printed from the Configuration Menu will not contain debug information or secondary codes
for 900 service errors. However, the event log printed from the Diagnostics Menu does include this information.
Paper Prompts
When a tray is out of the indicated paper size, a prompt is sent to the user to load paper in a tray. This setting
controls the tray the user is directed to fill. Selections are Auto (default), MP Feeder, and Manual Paper.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
