Lexmark C935 - Page 516

4-218 Printer Service Manual
5057-XXX
Go Back
Previous
Next
2
Perform the Skew fine setup printhead adjustment.
Select Cycle result values.
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Turn the appropriate printhead adjustment screws located
behind the waste toner cartridge the number of clicks
(rotation until a snap sound is heard and felt) based on the
above settings.
+values require turning the screw Clockwise
- values require turning the screw Counter Clockwise.
EG: Y-Skew adjustment 10. Turn the screw CW 10 clicks.
EG: Y-Skew adjustment -10. Turn the screw CCW 10 clicks.
Have the appropriate printhead adjustment screws been
adjusted?
Perform the In/Out
setup.
See “In/out
setup” on
page 4-222.
Adjust the
printhead
adjustment screws
then perform the
In/Out setup.
See “In/out
setup” on
page 4-222.
Step Check Yes No
K
C
M
Y
Printhead adjusting screw