Lexmark C935 - Page 106

2-14 Printer Service Manual
5057-XXX
Go Back
Previous
Next
925.00
Service PC
cartridge
Sensor (Y ATC) Outputs of the sensor (Y ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.00 Sensor (Y ATC)” on page 2-108.
925.01
Service PC
cartridge
Sensor (M ATC) Outputs of the sensor (M ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.01 Sensor (M ATC)” on page 2-108.
925.02
Service PC
cartridge
Sensor (C ATC) Outputs of the sensor (C ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.02 Sensor (C ATC)” on page 2-109.
925.03
Service PC
cartridge
Sensor (K ATC) Outputs of the sensor (K ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.03 Sensor (K ATC)” on page 2-110.
930.00 Black toner RFID
communication failure
Communication error with the K sensor (RFID toner
cartridge) has occurred.
Go to “930.00 Black toner RFID communication
failure” on page 2-110.
930.01 Cyan toner RFID
communication failure
Communication error with the C sensor (RFID toner
cartridge) has occurred.
Go to “930.01 Cyan toner RFID communication
failure” on page 2-111.
930.02 Magenta toner RFID
communication failure
Communication error with the M sensor (RFID toner
cartridge) has occurred.
Go to “930.02 Magenta toner RFID
communication failure” on page 2-111.
930.03 Yellow toner RFID
communication failure
Communication error with the Y sensor (RFID toner
cartridge) has occurred.
Go to “930.03 Yellow toner RFID communication
failure” on page 2-111.
940.00
Service MPF
failure
MPF Tray 5 size sensing
error
The MPF size width sensor has failed.
Go to “940.00 MPF tray 5 size sensing error” on
page 2-112.
941.00
Service tray 1
failure
Switch (media size) size
sensing error (tray 1)
The tray 1 switch (media size) detected an invalid
size setting.
Go to “941.00 Switch (media size) size sensing
error (tray 1)” on page 2-112.
Error code or
message
Error contents Description/Action