LIP-8008D User Guide
DND – Blocks all incoming calls; red LED illuminates.
Speed – Access speed dialing, speed programming.
Vol – Adjusts volume for ringing, headset, and
speakerphone; adjusts LCD brightness (in idle state).
Trans/PGM –Call transfer, or programming mode.
Hold/Save – Places active call on hold or saves
programming information.
Call Back – Initiates call back request when calling a
busy station; call is completed when busy station returns
to idle status.
Speaker – Allows User to place a call while on-hook.
Toggle to activate; red LED illuminates.
Flexible – Some are system pre-programmed for line
appearance, and some are user programmable.
Ring/MSG Indicator – Illuminates when ringing, or
message waiting.
LCD Display – Phone interface for status, dialing
directories, and text message information.
Soft Buttons – Used with fixed and flexible features;
use changes in relation to LCD display
Hands-free Microphone – Used for hands-free
speakerphone function.
1.5 LIP-8008D Phone Installation
LIP Phones can be connected to any standard 10/100
Base-T Ethernet switch port (shown in graphic). When
connected to an 802.3af compliant switch port (ex.,
POE8), LIP Phones obtain power from the Ethernet port.
When LAN power is available, do not use AC/DC
adaptor. When LAN power is not available, the AC/DC
adaptor must be used. The following image shows how
to connect the handset, power cord, and LAN cable to
the phone.
3
To Next Page
Loading...
Need help?
General
