Maeda MC285C-3 - Page 15

Mini-Crawler Crane M A E D A Table of Contents
1/2019 MC285C-3 xiii
Post-Start – After Starting Engine .......................................................................... 5-79
Over Winding Detector ...................................................................................... 5-79
Over-Unwinding Stop Device ............................................................................. 5-79
Moment Limiter for Operation (Auxiliary Winch Mode) ...................................... 5-80
Replacement of Winch Wire Rope.......................................................................... 5-80
Winch Wire Rope - Removal ............................................................................. 5-80
Winch Wire Rope - Installation .......................................................................... 5-81
AUXILIARY WINCH PERIODIC MAINTENANCE ............................................................ 5-83
Periodic Maintenance Schedule ............................................................................. 5-83
Periodic Maintenance Procedures .......................................................................... 5-83
Grease Machine Units ....................................................................................... 5-83
Check Oil Level and Refill Oil in Winch Reduction Gearcase ............................ 5-84
Replace Oil in Winch Reduction Gearcase ........................................................ 5-85
TROUBLESHOOTING ..................................................................................................... 5-87
Machine Body ......................................................................................................... 5-87
Engine .................................................................................................................... 5-88
Electrical Components ............................................................................................ 5-89
Remote Control System ......................................................................................... 5-90
Electric Motor ......................................................................................................... 5-91
Error Codes ............................................................................................................ 5-93
Slewing Position Calibration ................................................................................... 5-95