Maeda MC285C-3 - INSPECTION

Section 5 – INSPECTION Mini-Crawler Crane M A E D A
5-16 1/2019 MC285C-3
INSPECTION
Pre-Start and Post-Start Inspection Items
Inspection Item
Reference
Pre-Start - Visible Checks Before Starting Engine
Check Engine
See “Engine” on page 5-18.
Check Hydraulic System of Undercarriage
See “Hydraulic System of Undercarriage” on page 5-18.
Check Undercarriage
See “Undercarriage” on page 5-18.
Check Outriggers
See “Outriggers” on page 5-18.
Check Outrigger Cylinder
See “Outrigger Cylinder” on page 5-18.
Check Post
See “Post” on page 5-18.
Check Derrick Cylinder
See “Derrick Cylinder” on page 5-18.
Check Boom
See “Boom” on page 5-18.
Check Telescope Cylinder
See “Telescope Cylinder” on page 5-18.
Check Wire Rope
See “Wire Rope” on page 5-18.
Check Over Winding Detector
See “Over Winding Detector” on page 5-18.
Check Winch Motor
See “Winch Motor” on page 5-18.
Check Winch Drum
See “Winch Drum” on page 5-18.
Check Hook Block
See “Hook Block” on page 5-18.
Check Operation Levers
See “Operation Levers” on page 5-18.
Pre-Start - Before Starting Engine
Check / Add Engine Coolant Level
See “Check / Add Engine Coolant” on page 5-19.
Check / Add Engine Oil
See “Check / Add Engine Oil” on page 5-20.
Check / Add Fuel
See “Check / Add Fuel” on page 5-21.
Check / Clean Water Separator
See “Check / Clean Water Separator” on page 5-21.
Check / Clean Fuel Filter Pot
See “Check Fuel Filter Pot” on page 5-22.
Check / Add Hydraulic Oil
See “Check / Add Hydraulic Oil” on page 5-23.
Check / Add Slewing Motor Reduction Gearcase Oil
See “Check / Add Slewing Motor Reduction Gearcase Oil” on page 5-24.
Check / Clean Radiator and Oil Cooler Fins
See “Check / Clean Radiator and Oil Cooler Fins” on page 5-24.
Check / Add Battery Electrolyte
See “Check / Add Battery Electrolyte” on page 5-53.
Check Horn Operation
See “Check Horn” on page 5-24.
Check Working Light Operation
See “Check Working Light Operation” on page 5-25.
Check Fuses
See “Check Fuses” on page 5-25.
Check Cracks, Deformation or Damage of Boom and Frame
See “Check Cracks, Deformation or Damage of Boom and Frame” on page
5-25.
Check Deformation, Damage or Wear of Wire Rope
See “Check Deformation, Damage or Wear of Wire Rope” on page 5-25.
Post-Start - After Starting Engine
Check / Adjust Rubber Track Tension
See “Check / Adjust Rubber Track Tension” on page 5-26.
Check Rubber Tracks for Damage
See “Check Rubber Tracks for Damage and Wear” on page 5-26.
Check Outrigger Safety Device Operation
See “Check Outrigger Safety Device Operation” on page 5-26.
Check Outrigger Interlock Operation
See “Check Outrigger Interlock Operation” on page 5-26.
Check Outrigger Operation
See “Check Outrigger Operation” on page 5-27.
Check Crane Operation
See “Check Crane Operation” on page 5-28.
Check Over Winding Detector Operation
See “Check Over Winding Detector Operation” on page 5-29.
Check Moment Limiter Operation
See “Check Moment Limiter Operation” on page 5-29.
Check Emergency Engine Stop Switch (EMO)
See “Check Emergency Engine Stop Switch (EMO)” on page 5-30.
Check Engine Exhaust Gas Color, Noise and Vibration
See “Check Engine Exhaust Gas Color, Noise and Vibration” on page 5-30.
As Required
Replace Rubber Tracks
See “Removal of Rubber Tracks” on page 5-59.
Replace Winch Wire Rope
See “Winch Wire Rope - Removal” on page 5-65.
Check Wire Rope - Boom Telescope Extension
See “Wire Rope - Boom Telescope Extension” on page 5-68.