Maeda MC285C-3 - 4 B C Harge Capacity Abnormality; Slew Position Abnormality; Slew Detection Abnormality

Section 4 – MONITOR Mini-Crawler Crane M A E D A
4-18 1/2019 MC285C-3
57BConsumables Display
A warning is displayed if the replacement time
for consumables is approaching or has been
exceeded.
If a warning is displayed, replace the relevant
consumable and take the appropriate action.
See “CONSUMABLES” on 5-9.
58BAbnormality Display
A warning is displayed if an abnormality occurs
continuously in the machine.
62BEngine Oil Pressure Abnormality
A warning is displayed if an abnormality occurs
in the engine oil pressure circuit.
63BEngine Coolant Temperature
Abnormality
A warning is displayed if an abnormality occurs
in the engine water temperature circuit.
64BCharge Capacity Abnormality
A warning is displayed if an abnormality occurs
in the recharging circuit.
65BError Code Display
Displays an error code for the current error.
If multiple errors occur simultaneously, check
the error history display in user mode.
Fig. 4-41
NOTICE: Error codes are also displayed if faults
other than consumable related indications are
displayed. For more information on error codes,
see “Error Codes” on page 5-93, and take
corrective action.
Slew Position Abnormality
A warning is displayed if the slewing angle is
offset.
If a warning appears, see “Slewing Position
Calibration” on page 5-95 and calibrate the
slewing angle.
Fig. 4-42
Slew Detection Abnormality
A warning is displayed if an abnormality occurs
when using slewing operation lever limit switch
detection.
If a warning is displayed, see “Electrical
Components” on page 5-89 and take the
appropriate corrective action.
Fig. 4-43