Maeda MC285C-3 - REMOTE CONTROL SYSTEM INTRODUCTION

Section 4 – REMOTE CONTROL SYSTEM INTRODUCTION Mini-Crawler Crane M A E D A
4-78 1/2019 MC285C-3
REMOTE CONTROL
SYSTEM INTRODUCTION
This section describes the remote control system
operating procedures. Before you perform any
remote control system operating procedures, read
“Section 2 SAFETY.”
Upon using the remote control system, also refer
to HBC Operation Manual.
General
Modification
WARNING! Electrical Shock Hazard. Do not
dissemble or modify the transmitter, receiver
or accessories. Damage to the components
may result in electrical failure.
Fig. 4-210
Holding
Wear the waist belt, and operate the control levers
and buttons with your thumb. Firmly grasp the grip
with other fingers and hold the transmitter.
Fig. 4-211
Always manipulate levers and switches with your
fingers.
WARNING! Electrical Shock Hazard. Do not
use sharp objects or tools to operate the
transmitter. A sharp object or tool may
damage the transmitter, allowing water to
enter it and resulting in internal component
damage and/or electrical failure.
Washing
WARNING! Sudden Movement Hazard. Always
keep the transmitter clean and free of oil and
mud. A slippery or dirty transmitter may cause
an operator error.
Fig. 4-212
Wash the transmitter and receiver using a damp
cloth with water or mild detergent to remove dirt.
Avoid alkaline, alcoholic or spray cleaners that
deteriorate plastics.
WARNING! Electrical Shock Hazard. Do not
allow water to enter the transmitter. Only use a
damp cloth with detergent to clean the
transmitter. Damage to the transmitter may
result if water is allowed to enter it, resulting
in internal component damage and/or
electrical failure.