Section 4 – HANDLING TRANSMITTER BATTERY Mini-Crawler Crane M A E D A
4-106 1/2019 MC285C-3
Inspection after Ending Remote
Control System Operation
1. Inspect the transmitter and receiver after
ending remote control system operations.
a. Check operation levers and switches of
the transmitter for any faults.
b. Wipe off oil or dirt with a clean cloth.
c. Repair all cracks or damages without fail.
2. To store the transmitter, avoid places subject
to wind, rain, direct sunlight, high
temperatures and high humidity.
HANDLING TRANSMITTER
BATTERY
NOTICE: The battery used for the transmitter is an
exclusive battery.
Replacement Timing of Battery
If the battery runs low, recharge the battery or
replace the battery with a charged battery.
If the battery is not replaced, the transmitter will
stop in a few minutes.
Fig. 4-287
Replacement Method of Battery
Replace the battery of the transmitter in the
procedure described below.
1. Turn OFF the power of the transmitter.
Pressing the Emergency Engine Stop (EMO)/
Remote Control System Power OFF Switch
will turn OFF the power.
Fig. 4-288
2. Lift the battery upward while pushing it. The
battery comes off.
To Next Page
Loading...
