Maeda MC285C-3 - Page 196

Section 4 – INSTALLING AND REMOVING THE ELECTRIC UNIT Mini-Crawler Crane M A E D A
4-122 1/2019 MC285C-3
2. Remove the electric unit cover (1).
Fig. 4-320
3. Remove the four retaining bolts (4) on the
electric unit lower cover (3). Remove the
cover (3).
Fig. 4-321
4. Remove the four retaining bolts (6) on the
main unit frame lower cover (5)). Remove the
cover (5).
Fig. 4-322
5. Detach the three hydraulic hoses (7) from the
couplers.
Fig. 4-323
NOTICE: Check the position of the couplers. They
can be removed only when the ball and groove
are aligned.
Attach caps to the couplers after removal to
prevent ingress of dirt or water.
6. Detach the connectors (8) (9) (10).
NOTICE: Attach short connectors to the
connectors detached at the machine main unit
side.
The engine will not start unless these short
connectors are fitted.
Fig. 4-324
Fig. 4-325
Fig. 4-326