BIGFOOT GEAR HOUSING
Page 6B-52 90-857046R1 NOVEMBER 2001
3. Generously lubricate O-ring, bearing carrier, and gear housing mating surfaces with
2-4-C Marine Lubricant with Teflon.
4. Install bearing carrier and propeller shaft into housing with the word “TOP” (located on
flange) toward top of housing.
5. Install bearing carrier fasteners and tighten to specified torque.
21044
a
95
2-4-C Marine Lubricant with Teflon
95
b
a- O-ring
b- TOP
NOTE: Use thick 0.090 in. (2.29mm) washers (12-855941) under fasteners if not previously
installed.
Washer Thickness Fastener Torque
0.090 in. (2.29mm) 22 lb-ft (30 Nm)
0.060 in. (1.53mm) 25 lb-ft (34 Nm)
b
a
a- Washers
b- Fasteners (If using Screws Apply Loctite 271 on Threads)
To Next Page
Loading...
